Analysis of long-term closure in drifts excavated in Callovo-Oxfordian claystone : roles of anisotropy and hydromechanical couplings - PASTEL - Thèses en ligne de ParisTech Accéder directement au contenu
Thèse Année : 2016

Analysis of long-term closure in drifts excavated in Callovo-Oxfordian claystone : roles of anisotropy and hydromechanical couplings

Comportement différé de galeries dans l'argilite du Callovo-Oxfordien : rôles de l'anisotropie et des couplages hydromécaniques pour le dimensionnement des ouvrages

Résumé

The French National Radioactive Waste Management Agency (Andra) began in 2000 the construction of an Underground Research Laboratory (URL) with the main goal of demonstrating the feasibility of a geological repository in Callovo-Oxfordian claystone. Several research programs have taken place to improve the knowledge of the rock properties and its response to the excavation progress. A network of experimental drifts has been constructed with variations on: excavation method, structure geometry, supports system and orientations with respect to principal stresses’ directions. In each drift different sections have been instrumented to monitor the hydro-mechanical behavior of the rock mass formation. Continuous monitoring of the excavated zone around the drifts in the main level (-490 m) revealed the development of a fractured zone (extensional and shear fractures) induced by the excavation. The extent of this fractured zone depends on the drift orientation regarding the in-situ stress field. Accordingly, the convergence measurements showed an anisotropic closure which depends also on the drifts’ orientations. Moreover, marked overpressures and an anisotropic pore pressure field around the drifts have been also observed.The approach proposed in this work is mainly based on a direct analysis of the convergence measurements, for studying the anisotropic response of the rock formation during and after excavation. The convergence evolution is analyzed on the basis of the semi-empirical law proposed by Sulem et al. (1987) [Int J Rock Mech Min Sci Geomech Abstr 24: 145–154]. The monitoring and analysis of convergence data can provide a reliable approach of the interaction between rock mass and support. Therefore, the anisotropy and the variability of the closure are analyzed taking into account different field cases: drifts excavated in two different orientations (i.e. influence of the initial stress state), different methods, sizes and rates of excavation and different supports systems with different conditions of installation. This broad range of cases permits to refine the analysis for reliable predictions of the convergence evolution in the long term. This approach can thus be used for the design of various types of support and the evaluation of its performance in the long term.On the other hand, the pore pressure evolution induced by excavation of drifts as recorded in situ has been analyzed. The anisotropic response observed in-situ suggests that the intrinsic anisotropy of the material plays a key role in the response of the rock formation. To understand these phenomena, an anisotropic poroelastic analysis of the pore pressure evolution induced by the drift excavation is performed. The main goal is to simulate the main trends of the pore pressure evolution with a simple model taking into account the inherent anisotropy of the material. Finally, an analysis of the onset of failure shows the key role of the hydro-mechanical coupling on the extension of the failed zone around the drifts
L'Agence nationale pour la gestion des déchets radioactifs (Andra) a commencé en 2000 la construction du Laboratoire Souterrain de Meuse / Haute-Marne (LS-M/HM) avec l'objectif principal de démontrer la faisabilité d’un stockage géologique dans l’argilite du Callovo-Oxfordien. Un réseau de galeries expérimentales a été excavé, principalement en suivant les directions des contraintes horizontales (majeure et mineure), avec des variations sur : la méthode d'excavation, la géométrie de la structure et le soutènement. Chaque galerie a été instrumentée en différentes sections pour suivre le comportement hydromécanique de la roche face à l’excavation. Le suivi de la zone autour des galeries excavées au niveau principal (-490 m) a révélé le développement d'une zone fracturée (fractures en extension et en cisaillement) induite par l'excavation. La distribution de la zone fracturée dépend à la fois de l'orientation de la galerie et du champ de contraintes in-situ et a une influence importante sur la déformation des galeries. En effet, les mesures de convergence ont montré une fermeture anisotrope de la section de la galerie. De plus, il a été observé un champ de distribution anisotrope de la pression de pores ainsi que des surpressions autour des galeries.Afin d’analyser la réponse anisotrope du massif pendant l’excavation et après celle-ci, les travaux effectués dans le cadre de la thèse sont axés principalement sur une étude directe des mesures de convergence in-situ. Cette analyse s’effectue à l’aide de la loi semi-empirique proposée par Sulem et al. (1987) [Int J Rock Mech Min Sci Geomech Abstr 24: 145–154]. A cet égard, différentes galeries excavées dans le LS-M/HM ont été étudiées. Ces galeries présentent certaines différences dans leurs orientations et l’état initial des contraintes, dans la méthode et la vitesse d’excavation ainsi que dans les diamètres de la section et les types de soutènements installées. Cette analyse permet d’obtenir des prédictions fiables de la convergence à long-terme, ce qui peut servir pour le dimensionnement et la prévision de la performance du soutènement à long-terme.En outre, nous avons étudié la réponse anisotrope du champ de pression interstitielle observée in-situ. Cette analyse est basée sur une approche poroélastique anisotrope. L’objectif principal est de reproduire qualitativement l’évolution de la pression des pores autour des galeries avec une approche simple qui prend en compte l’anisotropie intrinsèque du matériau. Enfin, une analyse de l’apparition de la rupture montre le rôle clé que joue le couplage hydromécanique dans l’extension de la zone fracturée
Fichier principal
Vignette du fichier
TH2016PESC1120_complete.pdf (8.18 Mo) Télécharger le fichier
Origine : Version validée par le jury (STAR)
Loading...

Dates et versions

tel-01542407 , version 1 (19-06-2017)

Identifiants

  • HAL Id : tel-01542407 , version 1

Citer

Lina María Guayacan Carrillo. Analysis of long-term closure in drifts excavated in Callovo-Oxfordian claystone : roles of anisotropy and hydromechanical couplings. Geophysics [physics.geo-ph]. Université Paris-Est, 2016. English. ⟨NNT : 2016PESC1120⟩. ⟨tel-01542407⟩
444 Consultations
464 Téléchargements

Partager

Gmail Facebook X LinkedIn More